Cheap AC Current Permalloy Probe Clamp Type for 10A Electrical Tester
AC Current Permalloy Probe Clamp Q13-1 produced by GFUVE with the circular jaws to guarantee a very good accuracy and has improved ergonomic design and easy operation. It is sensor that is used for measuring alternating current. Q13-1 clamp is a simple external current sensor used to measure AC Current for electrical industry.
clamp on current probes are designed to extend the current measuring capabilities of DMMs, power instruments, oscilloscopes, hand-held scopes, recorders or loggers, and other diverse instruments.
The clamp on current probe is placed around the current-carrying conductor to perform non-contact current measurements without interrupting the circuit under test. The clamp outputs current or voltage signals directly proportional to the measured current, thereby providing current measuring and displaying capabilities to instruments with low current or voltage inputs.
When making a measurement, the current-carrying conductor circuit is not broken and remains electrically isolated from the instrument's input terminals. As a result, the instrument’s low input terminal may be either floated or earthed. It is not necessary to interrupt the power supply when using a current clamp for taking measurements, so costly downtime can be eliminated.
Measurement range of 1mA to 120A AC
Improved ergonomic design and easy operation
High content nickel metal core
Low phase shift for power measurement
Small, compact size
Jaw opening accommodates conductors up to 13mm diameter
Designed for DMMs, loggers, recorders and oscilloscopes
40Hz to 10kHz response
1mA/A AC output signals
Designed to EN 61010, 600V CAT III safety standard
UL, CE mark
Power quality measuring
Measuring around cable bundles
Power load monitoring
Energy meter calibrator
Measuring in breaker panels
Residential and commercial sites
1000: 1 or 2000:1 (customized)
0 - 100A AC
0 - 100mA AC (customized)
Max. Cont. Input current
Over voltage category
CAT III 600V
Output signal (AC current)
100mA AC at nominal input current
Output signal (AC voltage)
100mV,1V AC at nominal input current
3KV 50Hz/60Hz at 1 minute
-20°C to +55°C
2.5 meter cable with D01 connector
Max. voltage not insulated conductors
EN 61010-1, EN 61010-2-032, IEC60044-1
Lead output (2.5m)
Dimensions (L x W x H) (mm)
45 x 160 x 25
Holding wire diameter (mm)
Max. jaw opening (mm)
PC+ABS+Polycarbonate, UL94 V0
FAQ, following questions will help you to select the matched probe for your applications.
1. Please determine if you are measuring AC or DC?
GFUVE Current Permalloy Probe Clamp Q13-1 is for AC measurement.
2. What is the maximum current you will measure?
Q13-1 is 120A max.
3. What size conductor will you clamp onto? This parameter determines the probe jaw size needed.
Q13-1 can clamp conductor diameter is 13mm
4. What type of probe output do you need or can you work with (mA, mV, A, AC, etc.)?
Q13-1 Current Clamp can customize output with mA.
5. What is the working voltage of the conductor to be measured?
GFUVE Current Clamp should be used below 600 volts
6. What type of termination do you need: jacks, leads or BNC?
Current Probe Q13-1 standard has 2.5meter leads. We can offer jacks or BNC… as options.
7. If you cannot find information you need or would like assistance, contact us today. We have designed many more probes than those shown in this catalog, and we manufacture in Beijing, China.